Smeg MC30RA User Manual
Smeg Hobs
Advertising
Table of contents
Document Outline
- 1. PRECAUTIONS FOR USE
- 2. Instructions for disposal - Our environmental care
- 3. Safety instructions
- 4. intended use of the appliance
- 5. BEFORE INSTALLATION
- 6. INSTALLATION
- MEASUREMENTS FOR FITTED INSTALLATION
- MEASUREMENTS FOR EMBEDDED INSTALLATION OF THE MC30 MODULE + BARBECUE
- 6.4 Fixed installation
- 6.4.1 Installation of the module on a trolley placed side by side with the barbecue
- 6.4.2 Possible combinations
- 6.5 Connection of the appliance to the gas cylinder (liquid gas connection)
- 6.6 Check for any gas leaks
- 1 Open the gas valve on the LPG cylinder (or rotate the tap for Natural Gas supply), BUT DO NOT ATTEMPT TO LIGHT THE BURNERS.
- 2 With gas pressure in the hose, check for possible leaks on all the connections using a soap and water solution. Never use a naked flame to check for leaks.
- 3 In the event that there is a leak, bubbles will appear on the faulty connection where the gas is escaping.
- 4 Close the gas tap of the gas cylinder, tighten the leaking connection and then repeat the test.
- 5 If the gas leak persists, contact the nearest supplier.
- 7. ADAPTATION TO DIFFERENT TYPES OF GAS
- 7.1 Replacing nozzles
- 1 Extract the grid and remove all the caps and flame-spreader crowns;
- 2 Unscrew the burner nozzles with a 7 mm socket wrench;
- 3 Replace the burner nozzles according to the type of gas to be used (see point “8.1 Burner, nozzle and gas consumption characteristics”).
- 4 Replace the burners in the correct position.
- 7.1 Replacing nozzles
- 8. Connecting the appliance to the mains supply (natural gas connection)
- 9. Final operations for gas appliances
- 10. Know your appliance
- 11. the control panel
- 12. Using the Appliance
- 13. using the HOB
- 14. CLEANING AND MAINTENANCE