Sony 52NX800 - Manual (Page 15)

15
Setti
ng u
p
yo
ur TV
Running initial setup
1
Complete your cable connections
before proceeding with the Initial
Setup.
Connect the TV to your nearest power
outlet.
2
Check the ENERGY SAVING
SWITCH setting is on (z).
3
Press 1 (POWER) on the TV.
When you switch the TV on for the first
time, the Language menu appears on
the screen.
~
• The TV image shown here may differ from your
TV but the operation of your TV remains the same
as indicated.
4
Follow the instructions on the screen.
~
• The ENERGY SAVING SWITCH must be on
(z) to set the clock and obtain program
information for the TV Guide.
• Home mode sets the TV to display the settings
optimized for home viewing (this setting is
ENERGY STAR compliant).
5
Select Continue to scan for available
channels and enable the TV Guide On
Screen
®
feature. If you receive
channels from a cable box or satellite
receiver and do not wish to use the
TV’s built-in tuner, select Skip.
Selecting Skip will disable the TV
Guide On Screen feature, which is
only available when the TV’s tuner is
used.
~
• If you skip the channel scan while in the setup
menus, TV Guide will be disabled.
Detaching the Table-Top
Stand from the TV
Remove only the screws marked with on
the TV.
~
• Do not remove the Table-Top Stand for any
reason other than to install corresponding
accessories on the TV.
For KDL-60NX801, KDL-60/52/
46NX800 and KDL-46/40NX700
~
• The NX801/NX800/NX700 series models must
remove the stand rear cover prior to detaching the
Table-Top Stand.
• When installing the TV on a wall, remove the four
screws from the rear of the TV. (They are fastened
in the screw holes for wall mounting.) Be sure to
store the removed screws in a safe place, keeping
them away from children (except KDL-46/
40NX700).
• When attaching the Table-Top Stand again, be
sure to fasten the four screws (previously
removed) to the original holes on the rear of the
TV (except KDL-46/40NX700).
For KDL-55NX811, KDL-60/55/
46NX810, KDL-46/40NX711 and
KDL-46/40NX710
KDL-60NX810
Joint