Servis-Rhino DM124 - Manual (Page 87)

Operation Section 4-11
OPERATION
DM 07-02
© 2004 Alamo Group Inc.
STOP MOWER IMMEDIATELY IF IT BEGINS TO VIBRATE. OPERATING THE MOWER
WITH A VIBRATION MAY RESULT IN COMPONENT FAILURE. DETERMINE CAUSE OF
VIBRATION AND CORRECT. CHECK IF KNIVES ARE IN GOOD CONDITION AND
ROTATING FREELY. WIRE OR TWINE WHICH BECOMES ENTANGLED AROUND DISC
SHOULD BE REMOVED IMMEDIATELY AS IT MAY RESULT IN SEAL OR DISC BEARING
FAILURE. REPLACE WORN OR BENT KNIVES. REPLACE KNIVES IN PAIRS ONLY ON
EACH DISC. REPLACING ONLY ONE KNIFE WILL CAUSE UNBALANCE.
DO NOT OPERATE THE MOWER WHEN THE CUTTER BAR IS RAISED.
Special Operating Instructions
When cutting fine or dry grass or where grass is sparse, sharpen the blades or install new
blades to improve the cut.
DO NOT OPERATE THE MOWER IN ROCKY CONDITIONS. THE POSSIBILITY OF INJURY
FROM ROCKS THROWN BY THE DISCS IS MUCH GREATER IN THESE CONDITIONS.
NEVER ALLOW RIDERS ON TRACTOR OR MOWER DURING OPERATION!
CAUTION!
WARNING!
WARNING!
WARNING!