Southbend SB1354 - Manual

INSTRUCTION SHEET
P.O. Box 2027, Bellingham, WA 98227 U.S.A.
PHONE: (360) 734-1540 • www.southbendlathe.com
Model SB1354
Cast Iron Workbench Legs
Copyright © October, 2010 by South Bend Lathe Co.
WARNING: No portion of this manual may be reproduced without written approval.
#JB13348 Printed in Taiwan.
Cast Iron Legs w/Brass Nameplate .....................2
Material ................................................... Cast Iron
Finish ..................................................Powder Coat
Weight ..........................................110 Lbs. Per Leg
Dimensions ...........................................See Page 4
Capacity .................................. See Warning Below
Inventory
Specifications
Things You'll Need
During the assembly process you'll need the
following (not included):
For Assembly
• Two additional people
• Bench Top
• Lower Shelf
• Cross-brace
• Bench Mounting:
—Lag Screws 5 ⁄
16
" Dia. x Length (Bench
Thickness + 1 ⁄
4
") .........................................8
—Flat Washers 5 ⁄
16
" ........................................8
—Drill Bit 1 ⁄
4
" (pilot hole) ...............................1
• Lower Shelf Mounting:
—Lag Screws 1 ⁄
4
" Dia. Length (Shelf
Thickness) .................................................4
—Flat Washers 1 ⁄
4
" .........................................4
—Drill Bit 7 ⁄
32
" (pilot hole) ..............................1
• Cross-Brace Mounting:
—Dependent on cross-bracing used
• Tools needed for tightening selected
hardware
• Cardboard (or other protective material for
assembly process) larger than bench top
dimensions
Optional
• Leveling Feet 3 ⁄
8
"-16 thread pitch
• Precision Level
• Shim Stock (as needed)
• Floor Mounting Hardware (x4)
Figure 1. SB1354
(Bench top and shelf not included).
Designed with smooth flowing lines reminiscent
of industrial designs from the early 1900s, these
heavy Cast Iron Legs provide plenty of support
and stability for shop-made workbenches or
machine stands. Just add your own bench top
and bottom shelf to suit your particular needs.
Although each leg is capable of supporting
up to 2000 lbs., the actual capacity of the
completed workbench is dependent on many
factors, including (but not limited to) material
type, quality, and dimensions of the bench
top and shelf; the method and materials used
for cross bracing; the size and quality of the
hardware used; and any forces that may be
applied to the workbench during its use.