Samson DS70 - Manual (Page 7)

7
The illustration below shows the wiring for two channels of a DS70 being used in Bridged 70 volt mode. Since the two
input channels are bridged, a signal of up to 240 watts (into 8 ohms) can be received from the power amplifier. In this
kind of setup, the output level controls of the power amplifier can be used to control the volumes of each of the two zones.
For volume control of each of the speakers within a zone, an optional autotransformer can be used (see Appendix A on
page 9 of this manual for more information). Note that four speakers per channel are being used for purposes of
illustration only—any number of speakers (up to the rated wattage of the power amplifier or DS70) can in fact be used in
each zone. Note also that the the remaining two channels of the DS70 can be used to provide the same or different
output voltages.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
!
USE CLASS 2 WIRING
AVIS;
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
DO NOT EXPOSE THIS EQUIPMENT
TO RAIN OR MOISTURE.
emc
EUR . USA . JPN
BRIDGE
OFF ON
CH4 R CH3 R
CH4 CH3 4 Ω 120W
MAX. LOAD
- + + -
CH2 L CH1 L
- + + -
BRIDGE
OFF ON
SAMSON
SERIAL NUMBER
SERVO 4120
QUAD AMPLIFIER
SAMSON TECHNOLOGIES CORP., U.S.A.
AC
INLET USA & CANADA 115V - 60Hz
EUROPE & UK 230V - 50Hz
650W MAX.
CAUTION:
DISCONNECT SUPPLY CORD
BEFORE CHANGING FUSE.
FOR CONTINUED PROTECTION
AGAINST RISK OF FIRE, REPLACE
ONLY WITH SAME TYPE OF FUSE.
ATTENTION:
DEBRANCHER AVANT DE
REMPLACER LE FUSIBLE.
UTILISERUN FUSIBLE DE
RECHANGE DE MEM TYPE.
USA & CANADA
T 8A/125V (115V)
EUROPE AND UK
T 6.3A/250V (230V)
FUSE
- + + -
MONO 8 Ω - +
CH2 CH1 4 Ω 120W
MAX. LOAD
- + + -
MONO 8 Ω - +
COM COM 25.2V 70V
CH1 OUTPUT
COM COM 25.2V
NC 100V
70V
140V
CH2 OUTPUT
SAMSON
SAMSON TECHNOLOGIES CORP.
SPEAKER DISTRIBUTION SYSTEM
INPUT + – – +
CH3 CH4
INPUT + – – +
CH1 CH2
BRIDGE BRIDGE
BRIDGE 70V
COM COM 25.2V 70V
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
AVIS
RISQUE DE CHOC ELECTRONIQUE
NE PAS OUVRIR
DO NOT EXPOSE THIS EQUIPMENT
TO RAIN OR MOISTURE
SERIAL NUMBER
DS70
SPEAKER DISTRIBUTION
BRIDGE 100V
CH3 OUTPUT
NC 100V 140V
CH4 OUTPUT
BRIDGE 100V
COM COM 25.2V 70V
BRIDGE 70V
+ - + - + - + -
+ - + - + - + -
Two-Zone 70V (Bridged) Wiring