Soleus Air HGW-308 - Manual (Page 8)

Knob is at the " " position. [Fig 1]
Power Indicator
Light
Power Switch
Temperature
Control Dial
Heat Indicator
Light
OPERATING INSTRUCTIONS
PLEASE READ ALL INSTRUCTIONS BEFORE OPERATING HEATER!
Plug the power cord into a suitable electri-
cal outlet. The Green Power Icon will now
turn on.
[Rated not less than 115 volt].
Turn the power switch to the “I” position
for 1000W or “II” for 1500W.
Adjust the
Temperature Control Knob clockwise until the
Red Light Indicator turns on [Fig 2]. The Tem-
perature Control should begin.
Note: The Red Light Indicator will turn off
when the room reaches the desired tempera-
ture. After a while, as the room temperature
falls, the heater will turn on again and re-
lease heat until the room temperature rises
to the desired temperature. Desired room
temperature is maintained automatically by
this procedure.
You can adjust the temperature control
knob to increase or decrease the room tem-
perature as desired by turning the knob
clockwise or counter-clockwise direction as
shown in Fig 2.
8
Make sure the Temperature Control
Make sure the power switch is at off
position. [Fig 2]