Woodstock NAILER/STAPLER KIT W1775 - Manual (Page 14)

Model W1775 Nailer/Stapler Kit
-12-
CLEANING & LUBRICATION
Cleaning
Disconnect the nailer/stapler from the
air supply before cleaning. Use a good
solvent to clean the nose assembly of the
nailer/stapler. Always be sure that the
nailer/stapler is dry before using it again.
Do not allow dust, chips, sand, etc. into
the air connectors or into the body of the
nailer/stapler; this may result in leaks
and damage to the nailer/stapler and the
air couplings.
Lubricating
Standard pneumatic tool oil has been
included with your new Shop Fox nailer/
stapler to help maintain its useful life.
Place two to three drops of oil in the
nailer/stapler air inlet (as shown in
Figure 8) before every use, or after 2
hours of continuous use.
Figure 8. Lubricating nailer/stapler via
air inlet.
Never use gasoline or other
flammable liquids to clean this
tool. Vapors in the tool may ignite,
causing the tool to explode. Ignoring
this warning may lead to serious
personal injury or even death!
Wipe off any excess oil near the nailer/
stapler exhaust to avoid dust build-up.
When the oil that was included with the
nailer/stapler has been completely used,
replace with a quality pneumatic tool oil.
An alternative to manual oiling is to
install a lubricator in your air compressor
line. A lubricator eliminates the need to
oil your tool each time you use it. If you
have a lubricator in your air compressor
line, ensure it is functioning properly.