Skil 3400 User Manual
Page 60
1
2
3
5
5
4
6
FIG. 1
FIG. 2
2
5
5
4
3
1
FIG. 3
7
60.
TOOLS REQUIRED (FIG. 1)
10 mm Wrench
OR 10 mm Socket
Phillips Screwdriver
Adjustable End Wrench
Straight Edge
(MODEL 3400-12 ONLY)
BEFORE YOU ASSEMBLE THIS EXTENSION TO
MODEL 3400 TABLE SAW
Sort out and account for all parts to make sure that you have all
necessary materials to assemble your tool extension. Do not
discard packing material until all parts are accounted for (Fig. 2).
ITEM
DESCRIPTION
QTY.
1.
Table Extension
1
2.
Hex Head Bolt — 1/4-20 x 1 1/4"
2
3.
Hex Nut — 1/4-20
2
4.
Lockwasher
2
5.
Flat Washer
4
6.
Hex Head Leveling Screw
2
7.
Scale
1
HELPFUL ASSEMBLY HINTS
Assemble nuts and bolts finger tight only until completely
assembled as adjustments may be necessary.
This part may have sharp edges. Be careful in
handling to prevent being cut.
EXTENSION INSTALLATION (FIG. 3)
1.
Place extension 1 along desired side of table saw.
2.
Place flat washer 5 and hex head bolt 2 through holes at each
end of table and extension.
3.
Place flat washer 5, lockwasher 4 and hex nut 3 onto hex
head bolt as shown. Finger tighten nut.
4.
Tighten hardware just enough to allow adjustment of
extension.
5.
Using a straight edge, adjust extension to be flush with table
along top surface and front edge.
6.
Tighten nuts securely.
7.
Recheck with straight edge.
WARNING
!