SIIG 16556380 - Manual (Page 2)

2
Layout
The 1x2 VGA Splitter's image is shown below. The 4-port
and 8-port models come with 4 and 8 outputs,
respectively.
Figure 1: Rear Panel
On/Off switch
Power adapter jack
PC (input)
MONITOR (output)
Hardware Installation
1. Power off the computer and monitors you plan to
connect to this splitter.
2. Connect your computer’s VGA out to the splitter’s
PC connector using a VGA cable (not included).
3. Connect your VGA monitors to the splitter’s
MONITOR connectors using VGA cables (not
included).
4. Connect the splitter’s power adapter.
5. Turn on the monitors, then computer.
6. The VGA Splitter is now ready to use.
Note: To daisy chain, connect the MONITOR port
of the first splitter to the PC port of the next splitter.