Samsung SCC-C7478 - Manual (Page 16)

16 – 36x SMART DOME CAMERA
Operation
PRESET
Function
Max. 127 positions can be stored as Preset position.
The Preset number can be assigned from 1 to 128,
but 95 is reserved for starting OSD menu.
Camera characteristics (i.e. White Balance, Auto
Exposure) can be set up independently for each preset
and they are adjusted by using OSD menu. Four relay
outputs can be reacted in conjunction with one Preset.
Set Preset
<Set Preset> [1~128]
Run Preset
<Go Preset> [1~128]
Delete Preset
To delete Preset, use OSD menu.
AUTO PAN
Function
By using Auto Pan function, you can make camera
to move between 2 Preset positions repeatedly.
When Auto Pan function runs, camera moves
from the preset assigned as the 1st point to the
preset assigned as the 2nd point in CW(Clockwise)
direction. Then camera moves from the preset
assigned as the 2nd point to the preset assigned as
the 1st point in CCW(Counterclockwise) direction.
In case that the preset assigned as the 1st point
is same as the preset assigned as the 2nd point,
camera turns on its axis by 360° in CW(Clockwise)
direction and then it turns on its axis by 360° in
CCW(Counterclockwise) direction.
Speed can be set up from 1°/sec to 180°/sec.
Set Auto Pan
To set Auto Pan, use OSD menu.
Run Auto Pan
Method1) <Run Auto Pan> [Auto Pan NO.] [Enter]
•
•
•
•
•
•
•
Method2) <Go Preset> [Auto Pan NO.+140]
ex) Run Auto Pan 2 : <Go Preset> [142]
Delete Auto Pan
To delete Auto Pan, use OSD menu.
PATTERN
Function
Pattern Function is that a camera memorizes the path
(mostly curve path) by joystick of controller for assigned
time and revives the path exactly as it memorized.
4 Patterns are available and Maximum 1000
communication commands can be stored in a pattern.
Set Pattern
Pattern can be created by one of following two
methods.
Method 1) <Set Pattern> [Pattern NO.]
Pattern editing screen is displayed as bellow.
Movement by Joystick and preset movement
can be memorized in a pattern.
The rest memory size is displayed in progress
bar.
To save the recording, press NEAR key and to
cancel, press FAR key.
Method 2) OSD Using OSD Menu: See the section
“How to use OSD Menu”.
Run Pattern
Method 1) <Run Pattern> [Pattern NO.] [Enter]
ex) Run Pattern 2 : <Run Pattern> [2] [Enter]
Method 2) <Go Preset> [Pattern NO.+130]
ex) Run Pattern 2: <Go Preset> [132]
Delete Pattern
Use OSD menu to delete a Pattern.
a When the PATTERN is saved/executed, the PAN/
TILT is operated with AUTO FLIP OFF.
•
•
•
–
–
–
–
•
•
EDIT PATTERN 1
[NEAR:SAVE / FAR:DELETE]
0/0/X1/N