SpectronIQ PHT-300X - Manual (Page 11)

3
Setting Up the System
The following is the procedure for setting up your home theater system, complete with 5.1
channel surround sound system.
To set up the system:
1. Set the player in its intended location.
2. Connect the five speakers to the five
AUDIO OUTPUT terminals on the back of
the subwoofer. For each speaker, connect
the wire with the white stripe on it to the –
terminal, and connect the other wire to
the + terminal. For example, for the center
speaker, connect the white-striped wire to
CEN– and the other to CEN+.
To connect a wire, press down the tab,
insert the wire, then release the tab to
capture the exposed end of the wire.
3. Using the speaker cables, connect the the
5.1 channel audio outputs on the back of
the player to the associated AUDIO INPUT
connectors on the back of the subwoofer.
The outputs on the player have the same
layout as the inputs on the subwoofer, but
rotated.
You can also use the auxiliary input above
the 5.1 channel terminals (labeled L and R)
to connect a separate audio source to the
speaker system.
SL CEN FL Y Pb/Cb Pr/Cr S-VIDEO OPTICAL OUTPUT
5.1CH
AUDIO
COMPONENT
ON
OFF
120V
CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN
FL
CEN
AUDIO INPUT
FR
L R
SW
SL SR
FL– FL+
CEN– CEN +
AUDIO OUTPUT
FR+
SL– SL+
SR+ SR–
FR–
2.1CH
5.1CH SWITCH
OMPHT300X-1.book Page 3 Thursday, August 10, 2006 8:19 PM