Handset administration, Faqs – SpectraLink NetLink 8000 User Manual
Page 37
37
Adm
ini
str
ati
on
HANDSET ADMINISTRATION
FAQs
How does the handset power off and power on?
The
END
key is the power on/power off key. Press and hold it to
turn the handset on. Turn the handset off from the standby mode
by pressing and holding the
END
key. If you are in an active call, end
the call by pressing the
END
key. This returns the handset to the
standby mode, then press
END
again to turn the handset off.
How do I place a call and terminate a call?
To place a call, press the
START
key and then dial the number. End
the call by pressing the
END
key. You can also use the speakerphone
instead of the
START
key.
Can I change the ring?
The ring is fully adjustable and may be set differently for different
profiles. For a complete explanation of how to change the ring, see
the Profile Settings section of this guide.
How do I change the voice volume and the ringing volume?
Whether using a headset, the speakerphone, or the internal
speaker, the speaker volume for the current call may be raised or
lowered by pressing the up and down volume buttons on the side
of the handset.
The volume buttons may be pressed while the handset is ringing to
raise or lower the ring volume, which also changes the ring volume
setting in the current profile.
What is the range of the NetLink 8000 Series Wireless
Telephone?
As barriers affect radio transmission, there is no single answer for
this question. Normally, you can expect the same range as with any
other wireless device. However, if your facility has metal walls or
other materials that inhibit radio waves, the range will be reduced.
How do I charge the Battery Pack?
The Battery Pack in the handset may be charged in a Single or Dual
Charger without being removed from the handset by simply plac-