Sanyo PLC-WM5500 - Manual (Page 39)


ENGLISH
Setting up the projector
Click Setting on the main menu. This function is to set up the projector.
Select the sub menu [Screen setting] or [Setting] and then set up each set-
ting.
Setting up the projector
Item Description
Screen ..................... Switches the screen mode. (Normal, Full,
Wide(16:9), Zoom, True, Natural wide,
Custom) There may not be available
mode depending on the input source
and the setting of Screen aspect as
shown in the table below.
Ceiling ..................... Sets the image top/bottom and left/
right reversed. (ON, OFF)
Rear ........................... Sets the image left/right reversed. (ON, OFF)
Screen aspect .... Sets the aspect. {Default(16:10), 16:9, 4:3}
Reset......................... Resets the Screen settings.
Screen setting
This function is to adjust the screen mode of the projector. The values in the text box rep-
resent the current screen status.
✐ The mark "
4
" means that
the available screen mode
in the selected input
source system.
*1 The error message appears
when selecting the dis-
abled screen mode indi-
cated with "*1".
*2 Natural wide cannot be
selected when 720p, 1035i,
1080i or 1080p is selected
in AV system menu.
Screen Aspect Default(16:10) 16:9 4:3
Input source Input source Input source
Screen mode Video PC Video PC Video PC
Normal 4 4 4 4 4 4
Full 4 4 4 4 4 4
Wide(16:9) 4 4 *1 *1 4 4
Zoom 4 4 4 4 4 4
True *1 4 *1 4 *1 4
Natural wide *2 *1 *2 *1 *1 *1
Custom 4 4 4 4 4 4