Sanyo PLV-70 - Manual (Page 15)

15
BEFORE OPERATION
To insure safe operation, please observe following precautions :
● Use (2) AA, UM3 or R06 type alkaline batteries.
● Replace two batteries at same time.
● Do not use a new battery with an used battery.
● Avoid contact with water or liquid.
● Do not expose Remote Control Unit to moisture, or heat.
● Do not drop Remote Control Unit.
● If a battery has leaked on Remote Control Unit, carefully wipe case clean and install new batteries.
● Danger of explosion if battery is incorrectly replaced.
● Dispose of used batteries according to batteries manufacturers instructions and local rules.
Pull up lid and
remove it.
Remove battery
compartment lid. Slide batteries into
compartment. Replace compartment lid.
Two AA size batteries
For correct polarity (+ and
–), be sure battery
terminals are in contact
with pins in compartment.
Remote Control Batteries Installation
1 2 3
Operating Range
Point Remote Control Unit toward
projector (Receiver Window)
whenever pressing any button.
Maximum operating range for
Remote Control Unit is about 16.4’
(5m) and 60° in front and rear of a
projector.
16.4’
(5 m)
60°
16.4’
(5 m)
Used to adjust zoom.
(P20)
ON-OFF
FOCUS
D.ZOOM
ZOOM
MENU SCREEN
MUTE
1 1
2
2
3
3
4
Z F
Z F
D
D
KEYSTONE
KEYS
FREEZE
AUTO PC ADJ.
AUTO COLOR.M
NO SHOW
IMAGE INPUT
IMAGE INPUT
LENS SHIFT
LENS
V
O
L
U
M
E
V
O
L
U
M
E
SELECT
ZOOM BUTTON
FOCUS BUTTON
Used to adjust focus.
(P20)
NO SHOW BUTTON
Used to turn picture into
black image. (P21)
D.ZOOM BUTTON
Used to select DIGITAL
ZOOM +/– mode and
resize image. (P30)
KEYSTONE BUTTON
Used to correct
keystone distortion.
(P20, 37)
IMAGE BUTTON
Used to select image
level. (P27, 33)
60°
WIRED REMOTE JACK
When using as Wired
Remote Control, connect
Remote Control Cable to
this jack.
Battery installation is
required when using as
Wired Remote Control.
SCREEN BUTTON
Used to select screen.
(P30, 36)
COLOR MANAGEMENT
BUTTON
Used to operate COLOR
MANAGEMENT.
(P28, 34)