Sanyo DSR-M810 - Manual (Page 11)

3 INSTALLATION AND CONNECTIONS
10
English
INTRO
DUC
TI
ON
z Connect the cable of the wired remote control (VA-
RMN01) (sold separately) to the remote control input
terminals (among the control terminals).
Cut the plug off the cord, and connect the red wire to
“REMOTE” and the bare wire to “C”.
(1) Push in the lock pin with a flat-blade screwdriver.
(2) Insert the cable.
(3) Pull out the lock pin with a flat-blade screwdriver. The
cable is now fixed in place.
The VA-SW814/VA-SW81LITE application software (sold
separately) lets you control the digital video recorder, and
monitor live images, recorded images and audio through a
network.
1 When you have finished making all the
other connections, insert the power
plug into the wall outlet.
There is no power switch. All the indicators on the front
panel flash for approximately 30 seconds, then the POWER
indicator lights. The monitor screen displays the camera
image.
z When turning the power ON for the first time
“PLEASE SET THE CLOCK” is displayed on the monitor
screen. Follow the steps on P.12 to set the clock.
z If the clock is
already set
The operation display
area is displayed.
z If the POWER indicator flashes
The digital video recorder has a self-check function that
detects problems. If there is a problem at power ON or
during operation, the type of problem is indicated by how
rapidly the POWER indicator flashes. Contact a Sanyo
Authorized Service Center if the POWER indicator flashes.
4 flashes per second:
The hard disk is checked automatically at power ON. If
a hard disk problem is found, the POWER indicator
flashes, and the hard disk must be replaced or initialized.
If you need to save images stored on the disk, contact a
Sanyo Authorized Service Center.
1 flash per second:
Fan problem
z If you disconnect the power cable
Don’t move the digital video recorder for 30 seconds
after power OFF.
The disk in the hard disk drive briefly keeps spinning
after power OFF due to inertia, during which time the
head is unstable. At this time, the disk is sensitive to
shocks or vibrations, so avoid even light shocks.
Connecting cables to the control and
alarm terminals
Connecting to a network
RS485 REMOTE
A B C C
Bare wire Red wire
White
wire
VA-RMN01
Cable
Flat-blade screwdriver
HUB
HUB HUB HUB HUB
PC
DVR DVR DVR DVR
PC
Connecting the power cord
ALL RESET
LAN
MIC IN OUT IN OUT TV SYSTEM
NTSC
PAL
Power cable
HI A
05-20-04 AL 00015
08:30:45 ----------
Operation display area
e00_l8hae_us_7.book Page 10 Thursday, April 8, 2004 11:14 AM