ScyTek Electronics ASTRA 777 Mobile - Manual (Page 31)

1. Thoroughly read and become familiar with the installation instructions before beginning the instal-
lation.
2. Review system contents:
Main Unit 2 One-Way 5-Button Remote Transmitter
Siren Shock Sensor Harnesses Receiver Antenna
14-Pin main harness
4-Pin shock sensor harness
3-Pin door lock harness
LED harness
Valet Switch harness
Receiver Harness
3. Verify with the owner, the mounting locations for all visible components, including the LED and
Override switch.
4. Verify with the owner, the optional features of the Astra 777 Mobile and the functions that must be
programmed during installation.
5. Inspect and perform a function test of all vehicle systems before and after the installation.
6. Always use a Volt / Ohm meter for testing vehicle circuits. Never use a test light.
7. Always look before drilling any holes or mounting self-tapping screws. Be sure fuel lines and exte-
rior wiring looms are clear as they are often close to the chassis and difficult to see.
8. Protect all wires running from the engine compartment to the interior of the vehicle by covering
with electrical tape and split loom tubing. Be sure to use a grommet when routing wires through the
firewall.
9. Properly fuse any additional accessories such as window modules, door lock actuators, etc., mak-
ing sure to power them separate from the alarm module. This will ensure the functionality of the se-
curity system in the event of an accessory failure.
Page 28 - Astra 777 Mobile
S Sy ys stte em m IIn ntta alllla attiio on n