SUPER MICRO Computer H8QMI-2 - Manual (Page 41)

Chapter 2: Installation
2-23
2-11 Installing Software Drivers
After all the hardware and operating system have been installed, you need to install
certain drivers. The necessary drivers are all included on the Supermicro CD that
came packaged with your serverboard. After inserting this CD into your CD-ROM
drive, the display shown in Figure 2-7 should appear. (If this display does not
appear, click on the My Computer icon and then on the icon representing your CD-
ROM drive. Finally, double click on the S "Setup" icon.)
Click the icons showing a hand writing on paper to view the readme fi les for each
item. Click the tabs to the right of these in order from top to bottom to install each
item one at a time. After installing each item, you must reboot the system
before moving on to the next item on the list. You should install everything here
except for the SUPER Doctor utility, which is optional. The bottom icon with a CD
on it allows you to view the entire contents of the CD.
Figure 2-7. Driver Installation Display Screen