Smart Technologies Smart Board For Flat-PanelDisplays 99-00668-00 - Manual (Page 19)

99-00668-00 REV B0 Installing the Interactive Whiteboard 11
NOTE: Depending upon where and how the interactive whiteboard is mounted, you may need to
perform some of the following steps by touch due to reduced visibility.
1. Remove the thumbscrews from the pen tray bracket. You need these thumbscrews for step 3.
2. Slide the holes in the pen tray over the threaded posts on the pen tray bracket.
3. Attach the thumbscrews you removed in step 1.
CAUTION
Don’t connect the interactive whiteboard to the computer until after you've installed
SMART Board software. For more information, see page 5.
Thumbscrews
Pen Tray Holes
Threaded Post
Pen Tray
Thumbscrews