SECO-LARM USA Flush-Mount Low-Profile UFO Camera EV-6640-P3WQ - Manual (Page 3)

ENFORCER Flush-Mount Low-Profile UFO Camera
SECO-LARM U.S.A., Inc. 3
Before Starting:
Installation:
Overview:
1. Please read this manual carefully and keep it for
future reference.
2. Use the camera within given temperature and
electrical limits.
3. Do not mount the camera where it is exposed to rain or
other moisture, or in humid or dusty places.
4. Do not point the camera at the sun. Heat could damage
the camera, even when not in use.
5. Do not mount the camera in areas exposed to
radiation, strong magnetic fields, or strong
electrical signals.
6. Do not drop the camera or subject it to strong vibrations
1. Run a 12VDC power supply wire and a video cable with
a male BNC connector to the wall or ceiling where the
camera is to be mounted.
2. Temporarily connect the camera to the 12VDC
power supply.
3. Temporarily connect the camera’s female BNC
connector to the video cable’s male BNC connector.
4. While watching the monitor, hold the camera against the
wall or ceiling by hand where it is to be mounted, then
turn the camera until it is certain that this mounting
location is correct. Use a pencil to mark the location.
5. Disconnect the 12VDC power supply and video cable.
6. Drill a 2 1 /
4
” (56m) hole in the ceiling or wall where the
camera is to be mounted.
7. Twist the flange off the base and remove the
camera ball.
8. Place the ring bracket behind the hole.
Note: Ring bracket is not necessary if mounting
directly to wall.
9. Push the base into the hole, and secure to the ring
bracket using the three supplied marking screws.
10. Run the power supply and video cable through the
wall or ceiling to the hole, and through the bracket
and base. Connect to the camera’s power and video
connectors.
11. Hold the ball in the base, and secure with the flange.
Do not tighten securely.
12. Apply the power to the camera. Watch the monitor
and adjust the angle of the lens.
13. Secure the camera by tightening the flange.
14. Do a final test of the video camera and monitor.
DC Plug with
terminal block
DC Jack
Female BNC
connector
Flange
Camera ball
Screw
(1 Shown, 3 included)
Base Ring bracket
(inside the ceiling wa l)
Flange Base Ring bracket