Sony DSR-70 - Manual (Page 113)

Chapter 8
Connections and Settings
Chapter 8 Connections and Settings
113
Chapter
8
Connections and
Settings
Reference Video Signals for Analog Signal Editing
In order to provide stable video and audio signals for
analog editing, it is necessary for the built-in time base
corrector (TBC) to operate correctly. To ensure this,
input a reference video signal synchronized with the
video signal to the REF. VIDEO IN connector and set
the REF. VIDEO IN 75
Ω
termination switch to ON.
Connections for Cut Editing Using i.LINK Interface
(Optional DSBK-140 Required)
Using two DSR-70/70P units, each fitted with the
optional DSBK-140 board, as a pair of player and
recorder, you can configure a cut editing system.
For connections and settings, see the section “Connections
for Cut Editing Using Two DSR-70/70P Units” on page 36.
REF. VIDEO IN connector
and 75
Ω
termination switch