Stewart Filmscreen Corp Projection HDTV - Manual (Page 8)

This section provides instructions for attaching the screen to the frame.
You will need at least two people, one to support the screen, and one to
snap the screen in place. The viewing side of the projection screen is rolled
to the inside to protect the optical coating. The screen is rolled lengthwise,
with protective paper rolled in with the screen. The screen fabric attaches to
the frame with snap fasteners.
1. Remove the screen from the cardboard shipping tube.
2. Look at the frame and locate the snaps.
3. While supporting the screen roll, snap the screen into the frame
starting at the top left. Gently allow the screen to stretch onto the
snaps. Do not jerk the material, as it can rip. Refer to Figures 3
and 4. Attach the snaps on the top corners and top horizontal
section first, unrolling the screen as you go. Attach remaining
snaps.
6 Stewart Filmscreen Corporation
A
TTACHING THE
S
CREEN TO THE
F
RAME
Caution
‹ Be sure your hands and clothing are clean. Use of
gloves is recommended. Be careful not to touch or
scratch the image surface with fingernails.
‹ Do not use any tools to fasten the screen to the frame.
‹ Do not fold or crease the screen.
Figure 3: Unrolling the screen for attachment to the frame
Figure 4: Details of screen attachment