Scientific Atlanta DPX2213 - Manual (Page 7)

734348 Rev C 7
Introduction
Back Panel Description
The following illustration shows the description and function of the back panel
components on the DPX2213.
USB CABLE
POWER
ETHERNET 1/2
TELEPHONE REBOOT
EMTA 2
1 2 3 4 5 6
T11715
Important! Do not connect your PC to both the Ethernet and USB ports at the same
time. Your modem will not function properly if both the Ethernet and USB ports are
connected to your PC at the same time.
1 POWER – Connects the cable modem to the AC power supply that is provided
with your cable modem.
CAUTION:
Avoid damage to your equipment. Only use the AC power cord that is
provided with your cable modem.
2 CABLE – F-Connector connects to an active cable signal from your cable service
provider.
3 USB – 12 Mbps USB port connects to the USB port on your PC.
4 ETHERNET – RJ-45 Ethernet port connects to the Ethernet port on your PC or
your home network.
5 TELEPHONE 1 / 2 – RJ-11 telephone ports connect to home telephone wiring to
conventional telephones or fax machines.
6 REBOOT EMTA – Pressing this switch reboots the EMTA. Pressing this switch
for more than ten seconds resets the device to factory default values and reboots
the EMTA.
CAUTION:
The Reboot EMTA button is for maintenance purposes only. Do not use
unless instructed to do so by your cable or telephone service provider.
Doing so may cause you to lose any cable modem settings you have
selected.