Sony PEG-SJ30 User Manual

Page 25

Advertising
background image

25

Setting up your Sony CLIÉ Handheld – Basics

Chapter 2

When replacing the batteries

INSERT THE NEW BATTERIES WITHIN 1 MINUTE AFTER YOU

REMOVED THE EXHAUSTED ONES.
IF THE BATTERY IN YOUR CLIÉ HANDHELD IS FULLY
DISCHARGED OR REMOVED, ALL DATA STORED ON THE SDRAM
(MEMORY) IS LOST. IN SUCH A CASE, PERFORMING A
HOTSYNC

®

OPERATION ONCE THE BATTERIES ARE REPLACED

CAN RESTORE BACKED UP INFORMATION SAVED ON YOUR
COMPUTER (FROM THE LAST HOTSYNC

®

OPERATION) TO YOUR

CLIÉ HANDHELD.

• Be sure to turn your CLIÉ handheld off before removing/inserting

batteries.

• Be sure to replace both batteries with new ones.

Notes on batteries

• To avoid possible damage from battery leakage or corrosion,

observe the following:

- Be sure to insert the batteries with the +/– polarities matched

to the +/– marks.

- Do not charge the dry batteries.
- Do not use a combination of new and old batteries.
- Do not use batteries other than the types specified.
- Do not use a combination of different types of batteries.
- Do not use leaking batteries.

• Batteries left in your CLIÉ handheld for an extended period of time

will run down, even if your CLIÉ handheld is not used.

• Do not use manganese batteries in your CLIÉ handheld.
• When you are not going to use your CLIÉ handheld for a long time,

remove the batteries to prevent damage from battery leakage and
corrosion.

Charging the internal power source

To avoid losing data stored on your CLIÉ handheld, do not remove
new batteries during the first 1 hour after inserting them.
Your CLIÉ handheld has a small internal power source to maintain
your data while you switch batteries. This internal power source is
charged from the batteries when you first insert batteries into your
CLIÉ handheld or when you insert new batteries after a long period of
not using your CLIÉ handheld. Charging the internal power source
takes about 1 hour. If you remove the batteries before the internal
power source is charged, your CLIÉ handheld's memory will revert to
the factory settings and any data you have entered will be lost.

Advertising
This manual is related to the following products: