Sony BDP-CX7000ES - Manual (Page 69)

69
Set
tings
a
nd
Adj
u
st
m
e
nt
s
Audio Settings
The default settings are underlined.
Selects the jack type to output audio signals.
2-channel linear PCM signals are output at
48 kHz maximum from output jacks other
than the priority jacks.
To obtain the best possible surround sound,
set for the type of speakers you are using, and
their distance from your listening position,
then use the test tone to adjust the volume and
the balance of the speakers.
This setting is available when “Audio Output
Priority” is set to “Multi Channel Analogue.”
To set the speakers
1
Select “Speaker Settings” in “Audio
Settings,” and press
.
2
Select “Size,” “Distance,” and press .
3
Select a setup item using V/v, and press
.
4
Select and adjust settings using V/v, and
then pressing .
◆Size
Selects the size of the speakers.
• Front
• Centre
• Surround
• Surround Back
Audio Output Priority
HDMI Outputs audio signals from
the HDMI OUT jack.
Coaxial/
Optical Outputs audio signals from
the DIGITAL OUT
(OPTICAL/COAXIAL)
jack.
Multi Channel
Analogue Select this when connecting
an AV amplifier (receiver)
via the MULTI CHANNEL
OUTPUT jacks.
Stereo
Analogue Outputs audio signals from
the AUDIO OUT (L/R)
jacks.
Speaker Settings
Large Normally select this
position.
Small Select this when the
speakers cannot reproduce
adequate low frequencies.
Large Normally select this
position.
Small Select this when the speaker
cannot reproduce adequate
low frequencies.
None Select this if you do not
connect a centre speaker.
Large Normally select this
position.
Small Select this when the
speakers cannot reproduce
adequate low frequencies.
None Select this if you do not
connect surround speakers.
Large Normally select this
position.
Small Select this when the
speakers cannot reproduce
adequate low frequencies.
None Select this if you do not
connect surround back
speakers.
,continued