Swann Wireless Outdoor Cameras & Receiver - Manual (Page 4)

1. Directional Antenna
2. Channel Selector Button
4. DC Power jack
5.
6. Audio Out (L) jack
7.
3. IR Remote Receiver window and
Channel Display.
Video Out jack
Audio Out (R) jack
8. IR Remote Control
9. ON/OFF Switch
1. Omni-directional Antenna
3
5.
2. Infra-red LEDs
. Detachable Camera Stand
4. Microphone (enclosed in socket)
Power Cable & DC Power Socket
2
3
3
5
4
1
2
4
5
7
6
1
The Night Hawk Cameras can be switched to any of four frequencies to assist in avoiding
interference. Please see the illustration
for frequency settings. Unscrew the front of the
camera case to gain access to the channel switch. To change the frequency/channel on the receiver,
press the button on top of the receiver to cycle through the channels. You can also press the
button on the remote.
below
Channel & Frequency settings
By changing these switch settings, the frequency that the
Camera transmits on
. Once you have set the channel
on the Camera, select the same channel on the receiver. If you
experience interference try a different channel.
changes
Do not set both Cameras to the same channel or they
will interfere with each others signal.
12
12
Channel 1
Both switches Right
2414MHz
Channel 2
Top Left & Bottom Right
2432MHz
Channel 4
Both switches Left
2468MHz
Front view of Switch Block (note the numbers 1 & 2
indicate the left side of the switch) 12
Channel 3
Top Right & Bottom Left
2450MHz
1 2
12
•
• Please test all devices before final installation because transmission quality can often be
improved by moving the components slightly.
• To avoid the risk of damage to Night Hawk Camera Pack, use only the supplied power
adaptors.
Beware of humid locations. Water droplets or spray may damage the receiver unit. If
condensation does occur, do not use the equipment until it has dried out.
Do not cut the DC power cable of the Night Watch Camera to fit with another power source.
This may result in damage to the Night Watch Camera & any unauthorised modifications will
void your warranty.
DUE TO GOVERNMENT REGULATIONS RELATING TO THE USE OF COVERT
LISTENING DEVICES IN SOME COUNTRIES, YOU SHOULD CONSULT YOUR
LOCAL COUNTRY, STATE, COUNTY OR TERRITORY REGULATIONS FOR
RESTRICTIONS OR CONDITIONS OF THE USE OF SECURITY CAMERAS WITH
AUDIO CAPABILITIES
!
!
• Best Results are achieved where there is a clear “line of sight” between the
Camera/Transmitter and Receiver.
• Interference from certain electronic equipment or the moving human body can also affect the
range obtainable.
8
4 5
Camera Features Changing The Channel On The Night Hawk Camera
Receiver Features
Important Information About This Product
9