Sanyo LNS-W02 - Manual (Page 2)

LENS REPLACEMENT AND INSTALLATION PROCEDURE
Remove screws A (2 screws).
Pull down the lower lens cover while pushing
the part D, then remove it.
Remove screws B (2 screws).
Remove screws C (2 screws) and remove
upper lens cover.
1 5 Perform the steps to for lens replacement and installation.
1
1.
2.
A
Fig-1
Fig-3
●
IN CASE OF MODEL WITHOUT LENS
Remove 2 screws and pull down the plate.
2
3.
4.
UPPER LENS COVER
LOWER LENS COVER
C
B
D
D
COVER PLATE
REMOVE THE LENS COVER.
(At the step , insert the light-block sheet in the same
position as the removed cover plate has been placed.
Two screws are not used.)
Use the light-block sheet included with lens.
5
REMOVE THE COVER PLATE OF THE LENS COVER. (See figure-3)
Set the light-block
sheet, so that the
large rounder side
is set over the lens.
SCREWS
LIGHT-BLOCK SHEET
Fig-2
LENS COVER
Remove 4 screws of the lens cover and
remove the lens cover.
First, set the lens at the center position with
lens shift button.
First check the shape of cabinet.
In case figure-1 cabinet.
In case figure-2 cabinet.