SECO-LARM USA Enforcer 16/32 Channel 1U Rack Mount CCTV Power Supply PH-A3224-PUQ - Manual (Page 6)

ENFORCER RACKMOUNT POWER SUPPLY
6 SECO-LARM U.S.A., Inc.
E1. Locking Tab, front position
1. Install the front panel lock tab
using the screw from the power
supply front mounting point as
shown in Figure 6 to the right.
2. To open: Loosen the screw and
slide the lock tab toward the right
to let the front panel open.
3. To close: Slide the lock tab toward the left over the front panel and tighten the screw.
Note: When loosening the rack mount screw, it may be necessary to support the rear of the unit.
E2. Locking tab, side positions
1. Install the front panel lock tab
using the screw from the power
supply front mounting point as
shown in Figure 7 on the right.
2. To open: Loosen the screw
and rotate the lock tab upward
to let the front panel open.
3. To close: Rotate the lock tab downward so that it covers the front panel and tighten the screw.
Tech Tip: If the front panel lock tab falls off while opening, replace it starting with the tab
pointing up, and turn it down over the front panel.
F. Cable Management
1. There are two cable management options included with the product:
a. Cable management “G” brackets (x2). Screw the brackets onto any of the three mounting
points on the rear of the unit with the included M3x6 screws. Mount the brackets open end
at the top, as shown in Figure 8 below or Figure 11 on page 7.
b. Cable management hooks (x2). Press the white plastic hooks into any of the three mounting
holes on the rear of the unit as shown in Figure 8 below or Figure 11 on page 7.
Note: Cable management hooks, once inserted, cannot be removed.
2. Mount the brackets and route power cables in a way that best suits your installation. Be sure to
leave slack in the cable to ease future maintenance. Use cable ties to reduce cable tension.
See example in Figure 8 below.
Use cable ties to secure cables
to cable management bracket
Cable management hook Cable management bracket
Three mounting points
marked A, B and C
To cameras
Figure 6
Figure 7
Figure 8
32 31
Front panel
Front right mounting point
Front panel lock tab
Mounting screw
3
2 3
1
Front panel
Rack mount screw
Front panel lock tab
Mounting bracket