Woodstock D4041 - Manual (Page 2)

-2-
D4041 Miter Saw Stand Instructions
Inventory
In the event that any nonproprietary parts are missing
(e.g. a nut or a washer), we would be glad to replace
them, or for the sake of expediency, replacements can be
obtained at your local hardware store.
Box Contents: (Figure 2) Qty
A. Stand (not shown) .........................................1
B. Roller Assembly ............................................2
C. Roller Crossbar .............................................2
D. Wheel Brackets ............................................4
E. Wheels ......................................................2
Hardware: Qty
—Support Braces ...........................................2
—Hex Bolts M8-1.25 x 45 .................................2
—Hex Bolts M6-1 x 45 ................................... 12
—Flat Washers 6mm ..................................... 12
—Hex Nuts M6-1 .......................................... 12
—Lock Nuts M8-1.25 .......................................2
—Knobs M8-1.25 x 50 ......................................4
—Knobs M8-1.25 x 20 ......................................2
—Hex Bolts M8-1.25 x 50 .................................4
—Hex Nuts M8-1.25 ........................................8
—Flat Washers 8mm .......................................6
Assembly
1. Lay the work stand upside down and unfold the top
set of legs (inset in Figure 3). Make sure the locking
pins snap into place.
2. Place a wheel bracket on both sides of the wheel
and thread (1) M8-1.25 x 45 hex bolt through the
assembly (see Figure 3), then secure it with (1)
8mm flat washer and (1) M8-1.25 lock nut.
3. Place each wheel bracket assembly over the stand
leg, thread (4) M6-1 x 45 hex bolts through each
wheel bracket (see Figure 3), and secure them with
flat washers and hex nuts.
4. Unfold the remaining legs; install the support braces
between the legs with the remaining M6-1 x 45 hex
bolts, flat washers, and hex nuts.
5. Place the work stand upright, move the bottom of
the wheels approximately an 1 ⁄
8
" above the floor and
tighten the hex nuts.
6. Place the roller crossbar between the extension arms
and secure them with the M8-1.25 x 50 knobs, as
shown in Figure 4.
Figure 2. Model D4041 inventory.
D E
B
C
Figure 3. Wheel assembly.
Figure 4. Support roller assembly.
Roller
Crossbar
Roller
Assembly M8-1.25 x 20 Knob
M8-1.25 x 50 Knob