SOYO ETEQ82C663 AGP - Manual (Page 40)

Hardware Setup SY-5EHM/5EH5 V1.3
35
Step 19. Power On
You have now completed the hardware installation of your
Motherboard successfully.
1. Turn the power on
2. To enter the BIOS Setup Utility, press the <DEL> key while the
system is performing the diagnostic checks,
Note: If you have failed to enter the BIOS, wait until the boot
up sequence is completed. Then push the RESET button
and press <DEL> key again at the beginning of boot-up,
during diagnostic checks.
Repeat this operation until you get the following screen.
3. The BIOS Setup screen appears:
You are now ready to configure your system with the BIOS setup
program. Go to Chapter 3: BIOS SETUP
ROM PCI/ISA BIOS
CMOS SETUP UTILITY
AWARD SOFTWARE, INC.
STANDARD CMOS SETUP
BIOS FEATURES SETUP
CHIPSET FEATURES SETUP
POWER MANAGEMENT SETUP
PNP/PCI CONFIGURATION
LOAD SETUP DEFAULTS
LOAD BIOS DEFAULTS
INTEGRATED PERIPHERALS
SUPERVISOR PASSWORD
USER PASSWORD
IDE HDD AUTO DETECTION
SAVE & EXIT SETUP
EXIT WITHOUT SAVING
Esc
F10
: Quit
: Save & Exit Setup
↑ ↓ → ←
(Shift) F2
: Select Item
: Change Color
Time, Date, Hard Disk Type…