Smeg SE2642ID3 - Manual (Page 23)

Instructions for the installer
51
11.4 Hob seal
• Before installing, check that the hob seal is
attached properly.
• Ensure that no liquid gets between the frame of
the hob and the work surface, or between the hob
and the wall, as it could then fall onto appliances
below.
• If the hob is installed into a work surface which is
not flat, e.g. ones with ceramic or similar
coverings (tiles, etc.), any seal on the hob must be
removed and the cooking surface must be sealed
using plastic sealant.
• Do not fix the hob using silicon as this would make it impossible to uninstall the hob, if necessary,
without damaging it.
11.5 Section cut from the work surface
• Cut the work surface
precisely, using a good,
straight saw blade or a
vertical milling cutter. The
surfaces of the cut area
must then be sealed to
prevent the ingress of
moisture.
• The area for the hob must
be cut out in accordance
with the appropriate
designs.
• The glass ceramic cooking
surface must be perfectly
horizontal and perfectly
sealed. Installing it under
tension could lead to the
plate breaking.
• Check that the hob seal is
attached properly.
• The hob should be fixed in place using clips or tongues.
X = 770 mm Y = 730 mm
X = 600 mm Y = 560 mm