Simplicity 1693130 - Manual (Page 32)

28
Troubleshooting, Adjustment & Service
TRACTOR TROUBLESHOOTING CONTINUED
PROBLEM CAUSE REMEDY
Brake will not hold. 1. Brake is incorrectly adjusted. See Brake Adjustment.
2. Brake worn out See your dealer
Tractor steers hard. 1. Power steering Malfunction See your dealer.
2. Improper tire inflation. Check and correct.
3. Spindle bearings dry. Grease spindles. See Lubrication.
Low Oil Pressure Light is On 1. The engine oil pressure light may Light should go out immediately. If the light
go on when the engine is first stays lit, contact your dealer.
started; this is normal.
Irregular Voltage Light is On. 1. Battery discharged. Recharge or replace battery.
Or Volt Meter Indicates Irregular 2. Charging system malfunctioning. See you dealer.
Voltage Level
Differential Lock Won’t Engage
1. Differential lock cable See your dealer.
out of adjustment.
Cruise Control Won’t 1. Cruise lever tension See your dealer.
Stay Engaged out of adjustment.
2 Speed Control Won’t Shift 1. Operator Error. See Operation Section.
2. Transmission Failure. See Your Dealer.
Troubleshooting the Mower
PROBLEM CAUSE REMEDY
Mower will not raise. 1. Lift chains not properly attached Attach or repair.
or damaged.
Mower cut is uneven. 1. Mower not leveled properly. See Mower Adjustment.
2. Tractor tires not inflated See Maintenance Section.
equally or properly.
3. Attachment lift not fully lowered. Fully lower attachment lift.
Mower cut is rough looking. 1. Engine speed too slow. Set to full throttle.
2. Ground speed too fast. Slow down.
3. Blades are dull. Sharpen or replace blades. (See Mower Blade Service.)
4. Mower drive belt slipping Clean or replace belt as necessary.
because it is oily or worn.
5. Check PTO (Electric Clutch) See Adjustments Section.
Adjustment.
6. Blades not properly fastened See Servicing the Mower Blades.
to arbors.
6. Attachment lift not fully lowered. Fully lower attachment lift.
Engine stalls easily with 1. Engine speed too slow. Set to full throttle.
mower engaged. 2. Ground speed too fast. Slow down.
3. Carburetor improperly adjusted. See Engine Manual.
4. Cutting height set too low. Cut tall grass at maximum cutting
height during first pass.
5. Discharge chute jamming Cut grass with discharge pointing toward
with cut grass. previously cut area. Raise cutting height.
Excessive mower vibration. 1. Blade mounting screws Tighten to 45-55 ft.lbs. (61-75 N.m.).
are loose.
2. Mower blades, arbors, Check and replace as necessary.
or pulleys are bent.
3. Mower blades are out Remove, sharpen, and balance blades.
of balance. See Servicing the Mower Blades.
4. Belt installed incorrectly. Reinstall Correctly.
Excessive belt wear or breakage. 1. Bent or rough pulleys. Repair or replace.
2. Using incorrect belt. Replace with correct belt.
Mower drive belt slips 1. Idler pulley spring broken or not Repair or replace as needed.
or fails to drive. properly attached.
2. Mower drive belt broken. Replace drive belt.