Soleus Air KC-30H / KC-35H - Manual (Page 12)

10
4. Use a ³⁄₁₆" drill bit to drill 3 starter holes 1/2" deep through the
3 holes in the cabinet and into the windowsill.
5. Attach cabinet to windowsill with 3 - #10 x 1/2" pan-head
Phillips screws.
6. Check that air conditioner cabinet is tilted 1 / 2 bubble on
carpenters level to the outside so that water will run to
Attach Side Curtains to Window Frame
1. Pull left-hand curtain out until it fits into window channel. Use
a ³⁄₃₂" drill bit to drill a starter hole through the hole in the
curtain housing and into the lower window sash.
Front View
Top View
2. Insert one of the #10 x ³⁄₄" round-head screws through
hole and into lower window sash. Insert one of the
#10 x
³⁄₄" round-head screws through threaded hole in top
of curtain and one in bottom of curtain.
3. Repeat for right-hand curtain.
Complete Window Installation
1. Insert foam seal behind the top of the lower window sash and
against the glass of the upper window.
2. Place window-lock bracket on top of lower window and
against upper window sash.
3. Use a ³⁄₃₂" drill bit to drill a starter hole through the hole in the
bracket and into the window sash.
4. Attach window-lock bracket to window sash with
#10 x ³⁄₄" round-head screw to secure window in place.
Through-the-Wall Cabinet Installation
NOTES:
■ Handle air conditioner gently.
■ Be sure your air conditioner cabinet does not fall out of the
opening during installation or removal.
■ The location where the power cord exits the air conditioner
should be no more than 4 ft (122 cm) from a grounded
3 prong outlet.
■ Do not block the louvers on the front panel.
■ Do not block the louvers on the outside of the air conditioner.
■ It is the customer's responsibility and obligation to have this
product installed by a qualified technician familiar with
through-the-wall room air conditioner installations.
A. #10 x 1/2" pan-head Phillips screws
B. Windowsill
A. Left-hand curtain
B. Window channel
C. #10 x ³⁄₄ " round-head screw
A
A
B
B
A
C
A. #10 x ³⁄₄ " round-head screw
B. Hole for #10 x
³⁄₄
" round-head screw
A. Window lock bracket(2)
B. Foam seal C. Upper window glass
D. #10 x 1/2" pan-head Phillips screws (3)
A
B
A
B
C
D
D
the outside.