Sharp Notevision PG-C45X - Manual (Page 27)

Connections and Setup
-23
Connecting to a
Computer Using a DIN-
D-sub RS-232C Adaptor
and an RS-232C Serial
Control Cable
When the RS-232C terminal on the projector
is connected to a computer with a DIN-D-sub
RS-232C adaptor and an RS-232C serial con-
trol cable (cross type, sold separately), the
computer can be used to control the projec-
tor and check the status of the projector. See
page
89 for details.
1
Connect the supplied DIN-D-
sub RS-232C adaptor to an RS-
232C serial control cable (sold
separately).
2
Use the above cables to con-
nect the projector and the com-
puter.
Note
• Do not connect or disconnect an RS-232C
serial control cable to or from the com-
puter while it is on. This may damage your
computer.
• The RS-232C function may not operate if
your computer terminal is not correctly set
up. Refer to the operation manual of the
computer for details.
• See page
88 for connection of an RS-
232C serial control cable.
Optional
cable RS-232C serial control cable
Type: AN-C10RS (32'10" (10.0 m))
RS-232C terminal
To Audio
Output port
DIN-D-sub
RS-232C adaptor Supplied
accessory
Desktop computer
RS-232C serial control cable
(sold separately)
DIN-D-sub
RS-232C adaptor
Controlling the Projector by a Computer