Swann 4 CCTV Cameras Security Monitoring System - Manual (Page 3)

11 3
4
1. 4ch Security Kit Monitor
2. Monitor DC Power Adaptor (design may vary depending on country)
3. 4 x Security Cameras
4. 4 x RCA - DIN Signal Cable
2
Package Contents
FCC NOTICE WARNING STATEMENT
This device complies with Part 15 of FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation
WARNING: IMPORTANT
NOTICE ABOUT CORRECT
USE OF POWER ADAPTER
The correct orientation
for the enclosed power
adapter is in a vertical
or floor mount position.
L’orientation correcte pour
L’adapteur secteur fourni
est dans une position
verticale ou plancher-
monte.
La orientacion correcta para
el adaptador electrico incluido
es en posicion vertical o instalado
en el suelo.
No Image On Screen: Ensure power is correctly turned on. Check that
video cable is correctly connected and the connector has been plugged in
properly.
Blurry Image: Ensure lens is correctly fitted and if necessary re adjust
focus by rotating the lens until image is clear.
Image is too Bright or too Dark: Adjust the Brightness or Contrast
knobs on the back of the monitor until the image is clear.
Flicking Image: Adjust the V-Hold knob on the back of the monitor until
the image is stable.
Image not Switching: Ensure the Switching Mode button is set to
AUTO, you can also rotate the Dwell Time knob to the shorter time
setting.
How do I use the Audio/Video outputs on the monitor?
You will need to purchase an A/V cable with RCA male connections,
plug one and into the Audio/Video output sockets on the back of the
monitor, and the other end into your TV or monitor’s Audio/Video input
sockets.
If you have an A/V TV with RCA sockets you will need to switch the TV
to the AV channel to view the image. To view the image connected to
your VCR, you will need to select the AV input you have connected this
security monitor to on the VCR, turn your TV onto the channel you would
normally use to view a tape or movie on your VCR. This channel may be
activated by a button on your remote that is marked with this symbol ,
or L1 or L2 or possibly AV1 or AV2 . Please read the instructions for
your VCR or TV for more information on using their A/V inputs.
Trouble Shooting