Sharp AR-151 - Manual (Page 6)

4
1
Getting started
CAUTIONS
Follow the cautions below when using this copier.
● The fusing area is hot. Exercise care in this area when removing misfed
paper.
● Do not look directly at the light source. Doing so may damage your eyes.
● Do not switch the copier rapidly on and off. After turning the copier off, wait
10 to 15 seconds before turning it back on.
● Copier power must be turned off before installing any supplies.
● Place the copier on a firm, level surface.
● Do not install the copier in a humid or dusty location.
● When the copier is not used for a long time, for example, for consecutive
holidays, turn the power switch off and remove the power cord from the outlet.
● When moving the copier, be sure to turn the power switch off and remove the
power cord from the outlet.
● Do not cover the copier with a dust cover, cloth or plastic film while the power
is on. Doing so may prevent heat radiation, damaging the copier.
● Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
SAFETY PRECAUTIONS
This Digital Copier is rated Class 1 and complies with 21 CFR 1040.10 and 1040.11 of
the CDRH standards. This means that the copier does not produce hazardous laser
radiation. For your safety, observe the precautions below.
● Do not remove the cabinet, operation panel or any other covers.
● The copier’s exterior covers contain several safety interlock switches. Do not bypass
any safety interlock by inserting wedges or other items into switch slots.