Speco Technologies 650Line Intensifier3 Series Focus Free HTD8FFI - Manual (Page 23)

16
1) When the SPECIAL menu screen is displayed, press the Function
Setup switch so that the arrow indicates 'PRIVACY'.
2) Set up the mode using the Function Setup switch.
- AREA : You can select up to 12 PRIVACY areas.
- MODE : Determines whether to use the area selected in the AREA.
- MASK COLOR : Determine area color. You can select Green, Red, Blue, Black, White, Gray.
- MASK TONE : Adjust the brightness of MASK COLOR.
- TOP/BOTTOM/LEFT/RIGHT :Adjust the size and position of the selected area.
- RETURN : Select this to save the PRIVACY menu settings and return to the SPECIAL menu.
●
RETURN Setting
Select a desired RETURN mode using the Function Setup Switch.
- SAVE : Save the current settings and RETURN the MAIN SETUP menu.
- NOT SAVE : Do not save the current settings and RETURN the MAIN SETUP menu.
- RESET : Resets the camera settings to the factory defaults. Language,
Communication and Monitor Settings are not initialized.
- CAM ID : 1~255
- BAUD RATE : 2400, 4800, 9600, 19200, 38400, 57600
- UART MODE : 8-N-1, 8-E-1, 8-O-1
- RET PKT : ENABLE, DISABLE
- DISP ID : OFF, ON
- PROTOCOL : PELCO-D, PELCO-P, BOSCH, HONEYWELL, VICON, PANA, STW(SPD)
- RETURN
COMM ADJ
1.CAM ID
2.BAUD RATE
3.UART MODE
4.RET PKT
5.DISP ID
6.PROTOCOL
7.RETURN
1
2400
8-N-1
ENABLE
OFF
PELCO-D
◆ COMM ADJ