Sony BLU-RAY DISC BDP-BX57 User Manual

Page 30

Advertising
background image

30

The player cannot connect to the network.

, Check the network connection (page 15)

and the network settings (page 26).

You cannot connect your PC to the Internet
after “Wi-Fi Protected Setup (WPS)” is
performed.

, The wireless settings of the router may

change automatically if you use the Wi-Fi
Protected Setup function before adjusting
the settings of the router. In this case,
change the wireless settings of your PC
accordingly.

You cannot connect the player to the
wireless LAN router.

, Check if the wireless LAN router is on.
, Depending on the surrounding

environment, such as the wall material,
radio wave receiving condition, or obstacles
between the player and the wireless LAN
router, the communication distance may be
shortened. Move the player and the wireless
LAN router closer to each other.

, Devices that use a 2.4 GHz frequency band,

such as a microwave, Bluetooth, or digital
cordless device, may interrupt the
communication. Move the player away
from such devices, or turn off such devices.

The desired wireless router is not
detected even if “Scan” is performed.

, Press RETURN to return to the previous

screen, and try “Scan” again. If the desired
wireless router is still not detected, press
RETURN to select “Manual registration.”

The message “A new software version has
been found on the network. Perform
update under "Network Update."” appears
on the screen when turning the player on.

, See “Network Update” (page 21) to update

the player to a newer software version.

The “Control for HDMI” function does not
work (BRAVIA Sync).

, Check that “Control for HDMI” is set to

“On” (page 25).

, If you change the HDMI connection, turn

the player off and on again.

, If power failure occurs, set “Control for

HDMI” to “Off,” then set “Control for
HDMI” to “On” (page 25).

, Check the following and refer to the

instruction manual supplied with the
component.
– the connected component is compatible

with the “Control for HDMI” function.

– the connected component’s setting for

the “Control for HDMI” function is
correct.

, When you connect the player to a TV

through an AV amplifier (receiver),
– if the AV amplifier (receiver) is not

compatible with the “Control for HDMI”
function, you may be unable to control
the TV from the player.

– if you change the HDMI connection,

disconnect and reconnect the AC power
cord, or a power failure occurs, try the
following:

1

Switch the input selector of

the AV amplifier (receiver) so that the
picture from the player appears on the
TV screen.

2

Set “Control for HDMI” to

“Off,” then set “Control for HDMI” to
“On” (page 25). Refer to the instruction
manual supplied with the AV amplifier
(receiver).

Network connection

BRAVIA Sync (“Control for
HDMI”)

Advertising
This manual is related to the following products: