Source Technologies STM.57W - Manual (Page 10)

16 17
When the printer is installed initially or when you face a problem, you can run the
self test and check the information about
-Control Circuit, Mechanism, Print Quality, ROM Version
After checking with self-test and no issues are found, you can examine other
devices and software. This function is working independent of devices and software.
●
Motor protection from being overheated
The motor should be stopped and cooled about more than 30 seconds after
continuous printing 1.5 meter
4. Peripherals Connection
This product can communicate with other devices via Wifi(802.11b/g)
communication and cable.
1. The Printer can be connected to devices equipped with wifi(802.11b/g)
communication capacity (PDAs, PCs, etc.)
2. Use the wifi(802.11b/g) connection function supported by the device to
connect to the printer.
4-1 Wifi(802.11b/g) Connection
NOTE
Refer to the wifi(802.11b/g) Manual for more details on connection.