During recording and editing operations – Sony PDW-F70 User Manual
Page 110
110
Troubleshooting
A
ppen
dix
a) Displayed only when DISPLAY CONTROL >ALARM is set to “ON”.
b) Displayed only when DISPLAY CONTROL >ALARM is set to “ON” or
“LIMITED”.
During recording and editing operations
No SUB CLIP
a)
CLIP LIST CANNOT LOCATE SPECIFIED
SUB CLIP(S).
This appears when a playback button is pressed with
no sub clips in the current clip list.
Playback is not possible when there are no sub clips
in the current clip list.
SB CLP mode
b)
TO ADD AN ESSENCE MARK, EXIT
FROM SUB CLIP MODE FIRST.
This appears when you press the ESSENCE MARK
(SHIFT + THUMBNAIL) button with the SUB CLIP
button lit.
Try again after pressing the SUB CLIP button to turn it
off.
SUB CLIP NG
b)
SUB CLIP IS INVALID.
SET APPROPRIATE IN/OUT POINTS.
Set the In and Out points again.
No List!
b)
NO CLIP LIST.
This appears when you try to delete a clip list when
there is no clip list saved on the disc.
Load the disc that contains the clip list you want to
delete.
STOP ONCE!
b)
STOP ONCE, THEN EXECUTE.
This appears when you press the SUB CLIP button
during clip list playback.
Stop the playback and try again.
No EM space
ESSENCE MARK NOT RECORDED.
NO SPACE AVAILABLE TO RECORD
ESSENCE MARK.
Use the PDZ-1 Proxy Browsing Software to delete
unneeded essence marks.
EM Full!
NO MORE ESSENCE MARKS CAN BE
RECORDED.
Disc Damage
DISC CANNOT BE RECORDED TO.
USE ANOTHER DISC FOR RECORDING.
Use another disc.
NON-AV Full
DISC CANNOT BE RECORDED TO.
FOR MORE RECORDING SPACE,
DELETE CLIPS OR NON-AV DATA.
(GENERAL FILES)
Delete unneeded clips or GENERAL files.
Index File!
UNSUPPORT INDEX FILE.
DISC CANNOT BE RECORDED TO.
Use another disc.
File System
CURRENT VERSION OF THE
SOFTWARE SETS THE DISC WRITE
PROTECTED.
This appears when you insert a disc that can be
played back but not recorded.
Exchange the disc for one with a file system
supported by this unit. Or format the disc
41).
FILE SYSTEM ON THE DISC INHIBITS
WRITING.
Loading!
a)
LOADING.
This appears if you press a button while a disc is
loading. Wait until the disc has finished loading and
try again.
Unloading!
a)
UNLOADING.
This appears if you press a button while a disc is
unloading.
Wait until the disc has finished unloading and try
again.
Alarm message in time
data display section
Alarm message in monitor video
section
Description/action
Alarm message in time
data display section
Alarm message in monitor video
section
Description/action
Input Sig!”
a)
INPUT SIGNAL FREQUENCY IS NOT
THE SAME AS THE SYSTEM SETUP.
This appears when an input signal does not match
the system frequency of this unit.
Input a signal that matches the system frequency, or
change this unit's system frequency setting
23).