Sony 570WSPL - Manual (Page 22)

Chapter 1 Overview
22
Chapter 1 Overview
Location and Function of Parts
qa ALARM (alarm tone volume adjustment) knob
Controls the volume of the warning tone that is output
via the speaker (0 on page 21) or EARPHONE
connector (3 on page 18). Turning this knob to the
minimum setting mutes the alarm tone.
qs MONITOR (monitor volume adjustment) knob
Controls the volume of the sound other than the
warning tone that is output via the speaker (0 on page
21) or EARPHONE connector (3 on page 18).
Turning this knob to the minimum setting mutes the
audio output.
REC TIME SKIN DTL EXT VTR
OUTPUT
VTR
TRIGGER
AUDIO LEVEL
AUDIO SELECT
AUDIO IN
CH-1
LITHIUM BATT
MENU
TTL
DUR ON
OFF
OFF
TTL RESET
HYPER
GAIN
PARALLEL
PRESET
DATE/TIME
F-RUN
REGEN
F-RUN
R-RUN
VJ MIC
WIRELESS
SET
INT ONLY
EXT ONLY
FRONT
REAR
MIX
EXT
VBS
COMPONENT.
MONITOR SELECT
Y/C
SET
ClipLink
CONTINUE
ADVANCE SHIFT
CH-1
CH-2
ON
OFF
SETUP
FILE
STD
FRONT MIC
LOW CUT
ON
OFF
MONITOR OUT
CHARACTER
ON
OFF
AUTO
MAN
CH-2
1 MENU button
Press this button to display the VCR menu in the
display window.
For details about the VCR menu, see “Setting on the VCR
Section —VCR Menu” (page 117).
2 ADVANCE button
When setting time code and user bit values, or at menu
setting, press this button to increment the digit that has
been selected with the SHIFT button (3 on page 23).
In other case, keep pressing this button to show the
clip remaining indication instead of time value.
(Example:
CLIP 045)
For time code and user bit settings, see page 71.
On how to use the ADVANCE button for menu settings, see
“Setting on the VCR Section —VCR Menu” (page 117).
Operation panel under the cover
Right side
1 MENU button
2 ADVANCE button
3 SHIFT button
6 Lithium battery compartment
7 MONITOR OUT CHARACTER switch
8 TC mode switch 2
9 TC mode switch 1
0 ClipLink CONTINUE button
qa MONITOR SELECT switch
4 AUDIO SELECT
(CH-1/CH-2)
switches
5 AUDIO IN (CH-1/
CH-2) switches