Spirit XE 295 - Manual (Page 8)

XE195 / XE295 Elliptical
7
STEP 1: CONSOLE MAST ASSEMBLY
1. Locate the Console Mast (12) and Console Mast Cover (41) and slide the Cover onto the
mast as far as it will go. Make sure the Console Mast Cover is facing the correct way.
2. Unravel and straighten out the Computer Cable (31) and feed it into the bottom of the console
mast tube and out of the top opening.
3. Install the Console Mast into the receiving bracket in the top of the Main Frame. NOTE: there
is one bolt already installed in the receiving bracket that will engage with the slot at the bottom
of the Console Mast. This needs to be tightened at the end along with the three other console
mast bolts. Do not pinch the wire harness during this step.
4. Put one 3/8" x 2T Split Washer (96) onto the 3/8" x 2-1/4" Long Hex Head Bolt (60), and the
two 3/8" x 23mm Curved Washers (84) onto the two 3/8" x 3/4" Short Hex Head Bolts (103).
Install the Long Hex Head Bolt (60) through the left side of the receiving bracket into the
Console Mast and the short bolts (103) through the front.
Assembly Instructions XE195