Sherwood Enviro EG40 DV - Manual (Page 29)

29
CAUTION: Use only the type of
ember material supplied with this
appliance. Due to the irregular
size of the ember material there
may be more than required. The
use of other foreign materials on
the burners may create dangerous
conditions.
If over time, through cleaning and
servicing, these embers require
replacement, contact the nearest
ENVIRO dealer for replacement
embers.
The embers can be place before or
after the logs are placed. A bag of
ceramic fiber embers and rock wool
embers is provided gently remove
the ember material from the plastic
bag. Spread a layer loosely in a
random manner across the burner
tray. Do not allow any embers to
rest against pilot assembly. (See
Figure 31 or 34 for proper ember
placement.)
DO NOT pack this ember material
as this could create an unsafe
condition, leave embers loose
Carefully remove logs from box.
Check to ensure there is no damage.
It is very important to install all
logs in their proper position to
insure safe, optimum operating
conditions.
Figure 30: Step 1 of Log Placement.
Figure 31: Step 2 of Log Placement
Figure 32: Step 3 of Log Placement.
Secondary Installation
L
OG
S
ET AND
E
MBERS
I
NSTALLATION
:
The placement of the logs is not arbitrary. If they are positioned incorrectly, the flames can be “pinched”
and will not burn correctly. The burner come with five (5) locator pins, and the rear log has one (1) ledge,
which make alignment easier. Using the pictures provided, carefully set the logs in place.
NOTE: The logs are fragile and should be handled gently.