Sony CCU-TX50P - Manual (Page 5)

Function and Location of Parts and Controls
5
Function and Location of Parts and Controls
Front panel
a Camera number sheet/tally indicator
Lights red when the red tally signal is input (e.g. when
the video signal from the video camera connected to the
CCU-TX50/50P goes on air). When the CALL button
on the unit or RCP-D50 remote control panel is pressed,
the indicator lights red if it is not lit, and goes off if it is
lit.
The indicator lights green when the green tally signal is
input.
Attach the supplied number sheet here to indicate the
camera number.
b POWER switch/CAM (camera) and MAIN
indicators
The POWER switch turns on or off the power supply to
the entire camera system, including the CCU-TX50/
50P, the video camera, and the remote control unit
connected to the REMOTE connector on the CCU-
TX50/50P.
The MAIN and CAM indicators light when the POWER
switch is turned on.
The CAM indicator goes off when the power is turned
off by the CAM PW button on the remote control panel.
Note
If the fan in the CCU-TX50/50P stops, the MAIN
indicator will flash simultaneously to warn you of the
abnormal condition. If this occurs, turn the POWER
switch off immediately and contact Sony service
personnel.
c CABLE ALARM indicators
OPEN: Lights when no triaxial cable is connected to
the CAMERA connector on the rear panel of the
CCU-TX50/50P, or when the load current is
extremely low even when a camera cable is connected.
SHORT: Lights when there is a current overflow in
the triaxial cable.
d INCOM (intercom) input/output/setting section
INCOM (intercom) connector (XLR, 5-pin)
Connects a headset.
INCOM level control
Adjusts the input level of the headset.
MIC/PGM (program audio) switch
ON: Turns on the headset microphone.
a Camera number sheet/tally indicator
b POWER switch/CAM and MAIN indicators
c CABLE ALARM indicators
d INCOM input/output/setting section