Sony DVP-LS755P - Manual (Page 17)

17
H
ook
up
s
A
If you are connecting to a monitor, projector, or AV amplifier
(receiver) having component video input jacks (Y, P
B
/C
B
, P
R
/C
R
)
Connect the component via the COMPONENT VIDEO OUT jacks using a component video
cord (not supplied) or three video cords (not supplied) of the same kind and length. You will
enjoy accurate colour reproduction and high quality images.
If your TV accepts progressive 525p/625p format signals, use this connection and set the
NORMAL/PROGRESSIVE switch on the rear panel to PROGRESSIVE to accept progressive
video signals. For details, see “Using the NORMAL/PROGRESSIVE switch” (page 18).
B
If you are connecting to a SCART (EURO AV) input jack
Connect a SCART (EURO AV) cord (not supplied). Be sure to make the connections firmly to
avoid hum and noise. When you connect using the SCART (EURO AV) cord, check that the TV
conforms to S video or RGB signals. Refer to the operating instructions supplied with the TV to
be connected. Also, when you set “LINE” to “S VIDEO” or “RGB” under “SCREEN SETUP”
in the Setup Display (page 67), use a SCART (EURO AV) cord that conforms to each signal.
Set the NORMAL/PROGRESSIVE switch on the rear panel to NORMAL when using this
connection.
C
If you are connecting to a video input jack
Connect the yellow plug of an audio/video cord (supplied with UK models) to the yellow (video)
jack. You will enjoy standard quality images.
Set the NORMAL/PROGRESSIVE switch on the rear panel to NORMAL when using this
connection.
D
If you are connecting to an S VIDEO input jack
Connect an S VIDEO cord (not supplied). You will enjoy high quality images.
Set the NORMAL/PROGRESSIVE switch on the rear panel to NORMAL when using this
connection.
When connecting to a wide screen TV
Depending on the disc, the image may not fit your TV screen. To change the aspect ratio, see
page 67.
Green
Blue
Red
Green
Blue
Red
Yellow
White (L)
Red (R)
Yellow
White (L)
Red (R)
, continued