SanDisk Rhapsody - Manual (Page 10)

10
orange color visible.) Connect the small connector of the USB Cable to the USB
port on the computer, and then plug the larger end in to the Sansa e200R
Rhapsody Dock Connector. The computer must be on for most USB ports to charge
your battery. Your Sansa e200R Rhapsody will show connected and the yellow
charging indicator will appear. The battery level indicator will blink while charging.
You will not be able to play while connected to the computer USB.
2. To stop recharging, disconnect the cable.
If you are using an AC adapter (not included) or Car Adapter (not included), you will
be able to play your device while charging.
The Lithium Ion rechargeable battery will reach approximately 70% charge in 2.5
hours and full charge in about 3.5 hours. It is recommended that you fully charge your
Sansa e200R Rhapsody before first use.
Note: Some low-power USB ports may not be able to provide enough charge power.
Also note that rechargeable batteries may eventually need to be replaced as
they have limited charge cycles (which vary with use and settings).
Battery Level Indicator
Battery is Half Full
Battery is Low
Battery Replacement
The Lithium Ion rechargeable battery is replaceable. To purchase a replacement
battery, visit your local retailer or www.sandisk.com. Please follow the instructions
provided with the replacement battery.
Battery Warning
CAUTION : Do not disassemble, crush, short-circuit or incinerate
your battery as it may cause fire, injury, burns or other hazards.
Subscription Status
You can see the status of your Rhapsody subscription tracks at the bottom of the