Sharp AQUOS 10P06-MX-NM - Manual (Page 70)

68
• Detach the cable clamp on the rear of the TV when using the optional mount bracket.
• To use this TV mounted on a wall, remove the AC cord holder and the screws at the 4 locations on the rear of the TV, and
then use the screws supplied with the wall mount bracket to secure the bracket to the rear of the TV.
2 1
Setting the TV on the Wall
CAUTION
• This TV should be mounted on the wall only with the wall mount bracket AN-52AG4 (SHARP). The use of other
wall mount brackets may result in an unstable installation and may cause serious injuries.
• Installing the TV requires special skill that should only be performed by qualifi ed service personnel. Customers
should not attempt to do the work themselves. SHARP bears no responsibility for improper mounting or
mounting that results in accident or injury.
Using an optional bracket to mount the TV
• You can ask a qualifi ed service professional about using an optional AN-52AG4 bracket to mount the TV on the wall.
• Carefully read the instructions that come with the bracket before beginning work.
Hanging on the wall
AN-52AG4 wall mount bracket.
(See the bracket instructions for details.)
About setting the TV angle
Vertical mounting Angular mounting
LC-52LE920UN
0/5/10/15/20°
LC-60LE920UN
0/5/10°
AN-52AG4
LC-52LE920UN
• The center of the display:
3 /
64
inch (1 mm) above the “b” position.
LC-60LE920UN
• The center of the display:
43 /
64
inch (16.7 mm) above the “f” position.
• Refer to the operation manual of
AN-52AG4 for details.
Appendix