Smeg WM40T-1 - Manual (Page 3)

• If you will not use your machine for a long time, unplug your machine,
close the water supply and leave the door open in order to keep the
inside of the machine dry and for prevention from unpleasant odour.
• As a result of the quality control procedures, a certain amount of
water may remain in your machine. This is not harmful for your
machine.
SECTION 2: INSTALLATION
You must pay attention to the following issues before using your washing
machine.
REMOVAL OF TRANSPORTATION SCREWS
• Transportation screws, which are located at the back side of the
machine, must be removed before running the machine.
• Loosen the screws by rotating counterclockwise by a suitable wrench.
(DIAGRAM-1)
• Remove the screws by pulling them.(DIAGRAM-2)
• To the holes where the transport screws have been removed, insert
the plastic transport screw taps found in the accessories bag.
(DIAGRAM-3)
• The transportation screws, that have been removed from the machine
should be kept in hand for any other transportation necessities.
DIAGRAM-2
DIAGRAM-1
DIAGRAM-3
ADJUSTMENT OF FEET
• Do not install your machine on rugs or similar surfaces.
• For your machine to work silently and without any vibration, it should
be settled on a flat, non-slippery and tough ground.
30