Sennheiser EK 500 G2 - Manual (Page 24)

24
Selecting the standard display – DISLPY
Via the “ DISPLY ” menu, you can select the standard display:
Entering a name – NAME
Via the “ NAME ” menu, you can enter a freely selectable
name for the receiver. You can, for example, enter the name
of the performer for whom the adjustments have been
made.
The name can be displayed on the standard display and can
consist of up to six characters such as:
y letters (without pronounciation marks),
y numbers from 0 to 9,
y special characters e.g. () - . _ and spaces.
To enter a name, proceed as follows:
̈
Press the SET button to get into the setting mode of the
“ NAME ” menu. The first segment starts flashing on the
display.
̈
With the
̆
/
̄
rocker button you can now select a
character. By briefly pressing a button, the display
jumps either forwards or backwards to the next
character. If you hold down a button, the display starts
cycling continuously.
̈
Press the SET button to change to the next segment and
select the next character.
̈
Have you entered the name completely? Press the SET
button to store your setting and to return to the top
menu level.
Loading the factory-preset default
settings –
RESET
Via the “ RESET ” menu, you can load the factory-preset
default settings. Only the selected setting for the pilot tone
remains unchanged. After the reset, the receiver is restarted
and the standard display is shown on the display panel.
Selectable standard display Contents of standard display
“FREQ”
“NAME”
“CHAN”