Sharp FP-P40CX - Manual (Page 16)

1 hour
Cancel
4 hours
8 hours
ION AUTO
When pressed, the unit will switch between Clean
Mode and the Ion Control Mode automatically de-
pending on the amount of impurities in the air as
detected by the dust and odor sensors. Clean
Mode will operate for 1 minute when the Auto func-
tion is selected.
ION CONTROL
When pressed, the unit will constantly operate in
Ion Control Mode.
The Plasmacluster Ion Indicator Light is green.
CLEAN
When pressed, the unit will con-
stantly operate in the Clean Mode,
in which the same numbers of posi-
tive and negative ions are dis-
charged. The Plasmacluster Indica-
tor Light is blue.
ION OFF
The generation of ions will cease and
the Plasmacluster Indicator Light will
go out.
E-14
REMOTE CONTROL OPERATION
OPERATION
Operations available with
the Remote Control
• AUTO
• MANUAL
• POLLEN
• OFF TIMER
• QUICK CLEAN
• Lights ON/OFF
Plasmacluster Ion mode
selections
• ION AUTO
• CLEAN
• ION CONTROL
• ION OFF
POWER ON/OFF Button
• When you press the
POWER ON/OFF Button,
a short beep will sound
and operation will start in
AUTO Mode.
• Unless the power cord has
b e e n u n p l u g g e d , t h e
operation starts in the
previous mode the unit was
operated in.
• To stop, press the POWER
ON/OFF Button again.
A long beep will sound and
operation will stop.
Auto (Fan Speed) Button
The fan speed switches au-
tomatically depending on the
amount of impurities in the air.
Manual (Fan Speed) Button
T h e f a n s p e e d c a n b e
switched among Silent,
MEDIUM and MAX settings.
QUICK CLEAN Button
See page E-12
LIGHTS ON/OFF Button
Switches the Plasmacluster
Indicator Light and CLEAN-
SIGN Light either ON or OFF.
Pollen Mode Operation
Button
See Page E-12
Filter Reset Button
When the Washable Active Carbon
Filter is cleaned and reinserted into
the main unit, press the Filter
Reset Button with a pointed
instrument such as a pen.
The Filter Indicator light will then
go out with a beep.
Transmitter
Plasmacluster Ion Mode Selections
Off Timer Button
The set time switches every time
the button is pressed as shown
below.
• The indicator light shows the
remaining time.
• The unit will stop operation when
the time is up.