Samsung Digimax i6 - Manual (Page 11)

ŝ10Ş
Connecting to a Power Source Instructions on how to use the memory card
ƃ Repeated use of the memory card will eventually reduce the memory card’s
performance. Should this be the case, you will need to purchase a new memory
card. Wear and tear on the memory card is not covered by the Samsung
warranty.
ƃ The memory card is an electronic precision device. Do not bend, drop or knock
the memory card.
ƃ Do not store the memory card in an environment with strong electronic or
magnetic fields, e.g. near loud speakers or TV receivers.
ƃ Please do not use or store in an environment where there are extremes in
temperature.
ƃ Do not allow the memory card to become dirty or to come into contact with any
liquid. Should this happen, clean the memory card with a soft cloth.
ƃ Please keep the memory card in its case when not in use.
ƃ During and after periods of extended use, you may notice that the memory card
is warm. This is perfectly normal.
ƃ Before using a memory card from another digital camera, it must be re-formatted
in this camera before use.
ƃ If the memory card is used incorrectly, or if the power is switched off or the card
is removed while recording, the existing data may become corrupted.
ƃ Samsung cannot be held responsible for lost data.
ƈ Charging LED of the AC Adapter
ƃ A USB cable for transmitting data can’t be used for charging the rechargeable
battery.
ƃ A USB cable for recharging the battery is optional.
- When the USB cable for recharging the battery is inserted into the connection
terminal of the camera, you can charge the battery and transmit data at the
same time.
- When the USB cable for recharging the battery is inserted into the DC
connection terminal of the cradle, you can charge the battery.
When the USB cable for recharging the battery is inserted into the USB port of
the cradle, you can transmit data.
ƈ Charging time (When the camera is turned off)
- Using the cradle : About 150MIN
- Using the AC Charger : About 150MIN
ƃ If you insert the fully discharged battery to charge it, do not turn on the camera
at the same time. The camera may not be turned on because of the low
battery capacity. Charge the battery for over 10 minutes to use the camera.
ƃ Do not use the flash frequently or take a movie clip with the fully discharged
battery charged for a short time. Even if the charger is inserted, the camera
power may be turned off because the rechargeable battery is discharged again.
INFORMATION
Charging LED
Being Charged Red LED is on
Charging is complete Green LED is on
Charging error Red LED is off or blinking